How to install a high and low temperature thermostatic bathtub?

High and low temperature constant temperature water bathtub is a kind of equipment used for constant temperature experiments in the laboratory. The following are the installation steps: 1. Before installation, the equipment should be placed in a flat, clean and vibration-free place in the laboratory, and ensure that there is good insulation between the equipment and the ground. 2. Connect the power cord, pay attention to whether the power supply voltage is consistent with the required voltage of the equipment, and ensure that the power supply is stable, so as not to affect the normal use of the equipment. 3. Open the water tank of the equipment, add an appropriate amount of water, and note that the water quality should meet the requirements of the equipment. 4. Set the temperature of the device and set the temperature controller of the device to the required temperature value. 5. Connect the experimental instruments. If necessary, the experimental instruments can be connected to the equipment to ensure that the connection is tight and there is no leakage. 6.Start the device and check whether the device is working normally. 7. After the equipment runs stably, the experimental operation can be carried out. It should be noted that the operating procedures of the equipment should be followed during the operation to avoid any possible danger. At the same time, it is also necessary to maintain the equipment regularly to ensure the normal operation and service life of the equipment.