How to operate the tensile testing machine?

The operation steps of the tensile testing machine are as follows: 1. Before the test, determine the test material and choose the appropriate jig fixture. 2. Identify the test point and draw a mark on the client. 3. Fix and adjust the jig. The installation of the jig must be solid, and it cannot be shifted during the test. 4. Turn on the computer, open the pull test software, and log in. 5. Pull the elongation meter of the tensile tester to the test material, and adjust the direction of the test material to correspond to the jig. 6. Enter the basic physical data of the test material. 7. Click "Start Test" and wait for a few seconds. The system will pop up the dialog box to set the safety factor. After selecting the coefficient as needed, click "Confirm".8. The tensive test software will enter the test interface and start testing. At this time, the operator needs to observe the test data on the display. If any abnormality is found, press the "Stop" key in time to control it. 9. After the test, the pull test software will automatically process the data and generate the curve chart. 10. If you need to print, you can click the "Print" button to print. 11. After the data is processed, the operator should save the data in time. 12. Clean up the scene and get ready to retreat. The above are the operation steps of the tensile testing machine. I hope they can help you.